DRAFTMASTER SX DRIVER

Calibrating will display on the front panel and the calibration sequence will begin. Handle the film by the edges so as not to get fingerprints on it. When cutting and reloading the media, place the cut edge along the left side of the platen. Rotate the page 90 degrees clockwise and reload the media in the plotter. The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen. Please try again shortly. Then, check the following and start over:.

Uploader:	Togami
Date Added:	26 July 2004
File Size:	66.58 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	99874
Price:	Free* [*Free Regsitration Required]

Additionally, verify that the white stripe on the platen is clean. Carefully align the line on the left pinchwheel with the left edge of the draftmatser.

HP DraftMaster I, II, SX, RX and MX Plotters - Plotter Calibration

Turn the plotter off and then on again to clear the display. Pen 8 will then be retrieved from the pen holder and a square will be drawn. Remove the media from the plotter. The Eraftmaster Agent is currently unavailable.

HP DraftMaster I, II, SX, RX and MX Plotters - Plotter Calibration | HP® Customer Support

When reloading polyester film, place the writing surface face up; make sure the left pinch wheel is correctly aligned with the left edge of the plotting media. Europe, Middle East, Africa.

Javascript is disabled in this browser. If it does not have a paper cutter, use a sharp blade or draftmasster cutting device. Plotter parts have been changed pinch wheels, for example. Modify your browser's settings to allow Javascript to execute. The message Calibrating will display. Calibrating makes the plotter's drawing characteristics as accurate as possible.

The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen.

C Draftmaster SX Pen Plotter | eBay

Load a sheet of E or D size polyester film in the plotter. Load a black drafting pen in stall 8 of the pen carousel. Take care to accurately align dravtmaster left pinch wheel with the left edge of the media. The pen holder will move across the platen. When cutting and reloading the media, place the cut edge along the left side of the platen.

Then, check the following and start over:. Turn the plotter off and then on again before plotting. This includes both the stripe and the white dots on either side.

If the calibration fails, the message Calibration failed will display. Raise the plotter's carriage cover. Rotate the page 90 degrees clockwise and reload the media in draftmadter plotter. Calibrating will display on the front panel and the calibration sequence will begin. Make sure the pen is operational. This page requires Javascript.

Make sure the pen is in good operating condition and has a tip size of 0.

HP Computer Museum

When this process is complete, the plotter will display Cut page, rotate 90 degrees. If it has a rollfeed plotter, use the paper cutter to cut off the bottom of the page, flush with the slot in the plotter's platen.

Handle the film by the edges so as not to get fingerprints on it.

How does HP install software and gather data? Please try again shortly. The pen holder will move across the media several times, sensing the corners of the square just drawn. Pull the paper-loading lever towards you to raise the pinch wheels.